Specifications:

Hole capacity:	1-3/8" diameter
Hole depth:	2"
No load R.P.M.:	450
Arbor bore:	¾"
Electrics:	115 volt, 60 Hz, 7.2 amp
Dimensions:	8-1/4” L x 7-3/16” W x 16-7/16”H
Base size:	3-1/8” x 6-7/16”
Net weight (approximately):	28 lbs.
Magnet on 1” plate:
Drill point:	775 lbs.
Dead lift:	1,742 lbs.

 

Features:

• Drill holes up to 1-3/8" capacity in one pass - no step drilling
• Comes with its own heavy-duty carrying case
• Reversible handle allows you to get to “hard to reach” areas
• Unique rotabroach cutters cut faster, cleaner and with much less force required than with
  twist drills
• Slug is ejected automatically at the end of the cut
• Safety shut-off sensor located inside the magnet shuts off drill motor if lifting or shifting is
  detected
• Slide hammer impactor increases holding power of unit against spinning by about 500%,
  allowing for a smaller and lighter mag base to be used
• Chip demagnetizer is built-in