Specifications:

Capacity rating:	12 ga. x 4' mild steel sheet to 10" diameter
Top roll diameter:	4", 1045 steel rolls
Rolling speed:	14 FPM
Electrics enclosures:	12 NEMA, NFPA 79 specifications
Motor:	2 HP, 230/460, 3-phase, 60 hertz electrics
Approximate weight:	2,430 lbs.

Features:

• Heavy welded steel frame
• All slides accurately machined
• Rolls accurately machined from medium carbon steel
• Rolls are crowned to compensate for deflection under forming load
• Bearing cases machined from hardened alloy die steel
• Pinch rolls adjusted by dual hand wheels via a hardened screw and hardened wedge system
• Bending roll adjusted by hand wheel on end frame
• Bending roll position indicated by an accurate scale pointer system
• Bending roll adjusting mechanism consists of hardened steel worm and bronze worm gear running on a hardened steel screw
• Rolls are driven by a unique hydraulic motor, pump, valve arrangement providing instant start, stop and reverse
• Highly efficient American built hydraulic motor, pump and valves
• Power transmitted from low speed high torque hydraulic motor to rolls by a heavy spur hear drive train running on sealed ball bearings
• Pinch and top roll rotation powered
• Roll rotation forward and reverse, controlled by dual guarded foot pedal (main motor only runs when pedal is depressed)
• Industrial style safety cable switch with adjusting winch and reset button
• Top roll swings forward to remove finished tube/work piece

• All gear drive
• Sealed ball & roller bearings on all rolls and idler gears
• Unique high torque hydraulic drive system
• High quality American made hydraulic components
• Independent adjustment on pinch roll via a hand wheel/wedge arrangement
• Alloy steel bearing cases and wedges
• Bending roll adjusted with hand wheel via bronze worm gear/alloy steel screw arrangement, tiltable for cone rolling
• Instant start, stop and reverse via guarded foot pedal
• Safety cable on three sides of machine, front, rear and end
• Swing out top roll for easy work piece removal
• Starting groove in pinch roll to facilitate rapid workpiece prebending and rolling
• Stainless steel scale and pointer to show bending roll position
• Haze gray epoxy and safety blue enamel finish
• Entire machine built in Liberty, KY using purchased parts from American or world wide suppliers