The Metalmaster III is a unitized table and gantry cutting machine that utilizes the Hydefinition plasma process to produce excellent looking parts for the general fabrication market.  This machine is ideal for making parts for:
♦Air handling equipment
♦Ductwork
♦Kitchen equipment
♦Vessels and Tanks
♦Boats and Leisure Vehicles
♦Appliances
♦Precision Sheet Metal

The machine rides on a rugged, machined, modular steel base and track assembly.  The base supports a separate side draft exhaust cutting table.  Rail alignment is not affected if plates are accidentally dropped on the table.

The machine is a light, but very rigid aluminum structure.  This allows it to accelerate up to speed quickly and maintain accurate cutting even during corner moves.

Torch height is accurately maintained by means of the Messer PL-1 lifter.  Traveling at 880 in/min, it is capable of reacting to height changes quickly enough to follow warped or curved plate.  It is even fast enough to allow the MMIII to cut diamond plate, diamonds up!

Specifications:

Cutting area:	79” x 240”
Piercing & Cutting capacity: Mild Steel, Stainless Steel, Aluminum	26 gauge – 1”
Approx machine positioning speed:	880 inches per minute
Approx typical cutting speeds:	20 to 300 IPM (0.9 to 7.6 m/min) (Mild Steel)
Control unit:	Explorer – PC based CNC Control
Cutting current:	200 Amps @ 100% duty cycle
Table:	Fully ducted & zoned cutting table mounts within the track assembly.  The table supports up to 1” thick steel plate.
Dust Collector:	Free standing Messer (Torit) cartridge type dust collector Model # DFT2-8 with Messer Spark Trap
Electrical requirements:	230 volt, 1 phase, 60 Hz, 15 Amp
Floor space requirement:	10’ x 26’ (Machine and control unit only)
Machine weight:	7,000 lbs

 Equipped with:

• Hypertherm HD4070, Hydefinition plasma power unit
• Programmable torch lifter (PL-1)
• Torch guard collision sensor, X, Y, Z axes
• MTC Pronest Advanced Software Version 5.0
• Fully ducted and zoned cutting table
• Messer (Torit) DFT 2-8 Dust Collector
• Spark Trap
• Explorer PC-Based CNC Control

 

 

See Additional Photos Below